SSD2608PR Yako RS485 Bus Control Digital Stepper Drive

SSD2608PR Yako RS485 Bus Control Digital Stepper Drive

The SSD2608PR is a new Modbus-RTU, CANopen bus-integrated stepper motor that integrates RS-485 and CAN bus communication control technology. The stepping motor driver using standard Modbus-RTU bus protocol,  RS-485 isolated bus support,compared with the traditional combination of stepper motor drive and stepper motor with lower cost and more convenient installation, but also can effectively avoid the problem of stepping motor lose step, and effectively restrain the motor temperature rise significantly to reduce the vibration of the motor, greatly enhance the performance of high speed motor.

Features:

• 32-bit DSP technology, smooth, low noise and low vibration
• Supports standard MODBUS-RTU protocol with RS-485 isolated bus  
• Supports position control, speed control and multi-segment position modes 
• 5-channel optically isolated programmable input interface
• 3-channel optically isolated programmable output interface
• Smooth and accurate current control, low motor heating
• The effective value of the drive current is adjustable below 5.0A
• Voltage range: VAC24-80V
• Protection against overvoltage, undervoltage, overcurrent, etc

Application: 

can be widely used in engraving machines, special industrial sewing machines, wire stripping machines, marking machines, cutting machines, stage lighting, robots and medical equipment, laser equipment, marking machines, plotters and other automation equipment.

Dimensions

SSD2608PR Terminating Resistor Selection

Terminal Introduction