AS3-20CAI Yakotec/Yako 380V AC Servo Drive

YKD2405M-Plus open loop stepper drive optically isolated differential signal input, strong anti-interference ability, suitable for 42~86mm(NEMA17~34) 2 phase open-loop stepper motors.

YKD2608E open loop stepper motor driver feature for 32-bit DSP control, low noise and superior vibration performance. Smooth and accurate current control, effectively reduce motor heating

YKE2305M open-loop stepper drive feature for 32-bit DSP control, low noise and superior vibration performance, with over voltage, under voltage etc. fault protection.

42mm Series 2 Phase Close-loop Stepper Motor  Step accuracy: 5% Temperature: 80℃Max Ambient temperature: -20℃-+50℃ Insulation resistance: 100MR Min 500VDC Pressure resistance: 500VAC 1 minute Radial runout: Maximum 0.02mm (450g load) Axial runout: Maximum 0.08mm (450g load) Specification Model Step Angle (°） Motor Lenth (L) Holding Torque (N.m) Rated Current (A) Resistance (Ω） Inductance (mH) Rotor Inertia (g.cm²） Weight (kg) YK242EC51E1 1.8 79 0.5 1.85 1.0 1.9 77 0.53 YK242EC67E1 1.8 95 0.77 2.3 1.45 2.8 115 0.6 Suitable drive model: SSD2205M Dimensions Dimensions Model Shaft Diameter D (mm) Shaft Type (mm) Shaft Length L1 (mm)      YK242EC51E1 8 Flat 0.5*15 21 YK242EC67E1 8 Flat 0.5*15 21 Encoder Wiring Black GND Red +5V Blue/White EA- Blue EA+ Orange/White EB- Orange EB+ *Motor / Encoder cable: 0.3m Motor standard cable: 1.5m (optional 2m/3m) Encoder standard cable: 1.5m (optional 2m/3m) Motor connection

Transmission rate: 2x100Mbps (full-duplex), refresh time: 100 axes x 1µs/axis transmission delay = 0.1ms

Supports 1ms synchronization cycle. For synchronization cycles less than 1ms, it can support synchronization in multiples of 250µs. This makes it suitable for real-time-critical applications such as engraving and milling machines and printing presses.

Through precise adjustment of the EtherCAT distributed clock, 300 nodes can be connected over a distance of 120m with 15ns synchronization error and ±20ns synchronization jitter.

Using an RJ45 industrial Ethernet cable, the system allows for quick connection, significantly reducing wiring workload.

Stepper drive auto-setup measures motor parameters and configures motor current control and anti-resonance gain settings.

2 Phase Open-Loop Stepper Drive YKD2608MC feature for 32-bit DSP control, low noise and superior vibration performance 16, excellent smoothness in low frequency microsteps.

The AC stepper drive is powered from AC24-80V / DC30-110V and is intended for use with step motors designed to handle a high bus voltage.