Tel : 0755-86142288
Email : info@yankong.com
Item no.:
YKE2608MHPayment:
100% T/T payment before deliveryProduct origin:
Made in ChinaProduct weight:
0.5kgLead Time:
Confirm the PO, normally 7 workdays.YKE2608MH 2 Phase Open-Loop Stepper Drive DC18~80V
YKE2608MH open-loop stepper drive feature for 32-bit DSP control, low noise and superior vibration performance, with over voltage, under voltage etc. fault protection.
Features:
Application:
mainly used in medical equipment, dispensing machines, engraving machines, laser equipment,
labeling machines, electronic equipment, advertising equipment and other automation equipment.
Dimensions:
YKE2608MH Current Setting:
YKE2608MH Microstep Setting:
Terminal Introduction:
Symbol |
Function |
Specification |
|||||||
PWR |
Power indicator |
When power on, the green indicator lights up. |
|||||||
TM |
Work indicator |
Pulse signal indicator, when there is continuous pulse input, the green indicator light flashes, otherwise the green indicator light is always on. |
|||||||
O.C |
Fault indicator |
When over current or under voltage, the red indicator lights up. |
|||||||
DIR- |
SW9=OFF, it’s direction control signal |
Used to change motor direction. Requirements: low level 0~0.5V, high level 5~24V |
|||||||
SW9=ON, it’s CCW pulse signal |
Effects on falling edge, the motor moves a step when the pulse goes from high to low. It requires: low level 0~0.5V, high level 5~24V, pulse width>2.5us. |
||||||||
DIR+ |
Input signal+ |
Connect with the signal power supply, 5V~24V can drive, need to connect a current limiting resistor with DR- when >24V |
|||||||
PUL- |
SW9=OFF, it’s pulse signal |
Effects on falling edge, the motor moves a step when the pulse goes from high to low. It requires: low level 0~0.5V, high level 5~24V, pulse width>2.5us. |
|||||||
SW9=ON, it’s CW pulse signal |
Effects on falling edge, the motor moves a step when the pulse goes from high to low. It requires: low level 0~0.5V, high level 5~24V, pulse width>2.5us. |
||||||||
PUL+ |
Input signal + |
Connect with the signal power supply, 5V~24V can drive, need to connect a current limiting resistor with PUL- when >24V |
|
||||||
MF- |
Motor free signal -
|
When effective (low level), the motor coil current is turned off, motor free and alarm signal cleared. |
|||||||
MF+ |
Input signal + |
Connect with the signal power supply, 5V~24V can drive, need to connect a current limiting resistor with MF- when >24V |
|||||||
-V |
Power supply- |
AC18~80/DC24~110V |
|||||||
+V |
Power supply + |
||||||||
+A,-A |
Motor connection |
|
|||||||
+B,-B |